The original post: /r/datahoarder by /u/FabadaLosDomingos on 2024-12-06 19:30:22.
I just bought a 16TB HDD from seagate (from amazon). The drive is brand new, I had a problem mounting it and when i ran a healthcheck and realised I have 0 idea what any of it means. Does this mean that I formatted my drive incorrectly (ext4) or maybe that I should overriwrite the whole drive?
server@linux:~$ sudo smartctl -a /dev/sda
smartctl 7.4 2023-08-01 r5530 [x86_64-linux-6.10.11-200.fc40.x86_64] (local build)
Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Device Model: ST16000NM000J-2TW103
Serial Number: ZRS1FQXE
LU WWN Device Id: 5 000c50 0e899264f
Firmware Version: SN02
User Capacity: 16,000,900,661,248 bytes [16.0 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Device is: Not in smartctl database 7.3/5528
ATA Version is: ACS-4 (minor revision not indicated)
SATA Version is: SATA 3.3, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Fri Dec 6 20:25:51 2024 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82)Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0)The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 567) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003)Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01)Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: (1424) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x70bd)SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 050 050 044 Pre-fail Always - 36361577
3 Spin_Up_Time 0x0003 098 098 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 2
5 Reallocated_Sector_Ct 0x0033 100 100 010 Pre-fail Always - 28
7 Seek_Error_Rate 0x000f 100 253 045 Pre-fail Always - 46649
9 Power_On_Hours 0x0032 100 100 000 Old_age Always - 1
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 2
18 Unknown_Attribute 0x000b 100 100 050 Pre-fail Always - 0
187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 108
188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 069 066 000 Old_age Always - 31 (Min/Max 27/34)
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 2
193 Load_Cycle_Count 0x0032 100 100 000 Old_age Always - 8
194 Temperature_Celsius 0x0022 031 040 000 Old_age Always - 31 (0 23 0 0 0)
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 98
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 98
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
200 Multi_Zone_Error_Rate 0x0023 100 100 001 Pre-fail Always - 0
240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 0 (65 187 0)
241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 36146800
242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 214777
SMART Error Log Version: 1
ATA Error Count: 195 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 195 occurred at disk power-on lifetime: 1 hours (0 days + 1 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 53 00 08 c9 00 00 Error: UNC at LBA = 0x0000c908 = 51464
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 08 c9 00 40 00 00:51:21.067 READ DMA EXT
25 00 40 00 c9 00 40 00 00:51:16.658 READ DMA EXT
25 00 01 08 c9 00 40 00 00:51:13.611 READ DMA EXT
25 00 40 00 c9 00 40 00 00:51:10.587 READ DMA EXT
25 00 40 00 49 00 40 00 00:51:09.722 READ DMA EXT
Error 194 occurred at disk power-on lifetime: 1 hours (0 days + 1 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 53 00 08 c9 00 00 Error: UNC at LBA = 0x0000c908 = 51464
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 40 00 c9 00 40 00 00:51:16.658 READ DMA EXT
25 00 01 08 c9 00 40 00 00:51:13.611 READ DMA EXT
25 00 40 00 c9 00 40 00 00:51:10.587 READ DMA EXT
25 00 40 00 49 00 40 00 00:51:09.722 READ DMA EXT
25 00 40 40 08 00 40 00 00:51:08.859 READ DMA EXT
Error 193 occurred at disk power-on lifetime: 1 hours (0 days + 1 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 53 00 08 c9 00 00 Error: UNC at LBA = 0x0000c908 = 51464
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 01 08 c9 00 40 00 00:51:13.611 READ DMA EXT
25 00 40 00 c9 00 40 00 00:51:10.587 READ DMA EXT
25 00 40 00 49 00 40 00 00:51:09.722 READ DMA EXT
25 00 40 40 08 00 40 00 00:51:08.859 READ DMA EXT
25 00 40 00 08 00 40 00 00:51:08.212 READ DMA EXT
Error 192 occurred at disk power-on lifetime: 1 hours (0 days + 1 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 53 00 08 c9 00 00 Error: UNC at LBA = 0x0000c908 = 51464
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
25 00 40 00 c9 00 40 00 00:51:10.587 READ DMA EXT
25 00 40 00 49 00 40 00 00:51:09.722 READ DMA EXT
25 00 40 40 08 00 40 00 00:51:08.859 READ DMA EXT
25 00 40 00 08 00 40 00 00:51:08.212 READ DMA EXT
25 00 40 80 00 00 40 00 00:51:08.210 READ DMA EXT
Error 191 occurred at disk power-on lifetime: 0 hours (0 days + 0 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 53 00 68 14 00 00 Error: UNC at LBA = 0x00001468 = 5224
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 08 68 14 00 40 00 00:35:01.663 READ FPDMA QUEUED
60 00 08 60 14 00 40 00 00:35:01.645 READ FPDMA QUEUED
60 00 08 58 14 00 40 00 00:35:01.423 READ FPDMA QUEUED
60 00 08 50 14 00 40 00 00:35:01.369 READ FPDMA QUEUED
60 00 08 40 14 00 40 00 00:35:01.166 READ FPDMA QUEUED
SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]
SMART Selective self-test log data structure revision number 1
S...
***
Content cut off. Read original on https://old.reddit.com/r/DataHoarder/comments/1h89kfn/issue_with_new_bought_hdd_16tb_seagate/You must log in or register to comment.