The original post: /r/homelab by /u/Slight_Card812 on 2024-06-07 02:34:55.
Hello everyone!
I’m thinking of purchasing a managed L3 switch. My problem is I have at&t fiber (nothing wrong with the service) and am using their router/modem combo. The BGW320-500 only has one fiber port but I would like to connect fiber to whichever L3 switch I end up with. I’m not sure how to go about this as I’m rather new to homelabbing as a whole. Any advice on this is appreciated. If there’s another reddit this might be better off in, please let me know. Pictured below is the BGW320-505 but it’s essentially the same as the 500. Note the one SFP port at the bottom.
You must log in or register to comment.